Inverter type wire welding device for both wire welding and electrode welding, as well as TIG welding (LIFT lifting ignition)

Based on IGBT transistors. With single-phase power

Welding current max. 200 A for wire welding, 160 A for electrode welding and 200 A for TIG welding

The device is equipped with synergic control for MIG/MAG welding, allowing to set parameters manually.

Available programs: Steel with 0,6mm wire, 0,8mm wire, 1,0mm wire

A simple control panel allows you to adjust the following MIG/MAG parameters:

welding arc voltage, wire feed speed, 2T/4T mode, inductance, Arc Force (easier electrode melting in electrode welding), Hot Start (better electrode ignition) and VRD-reduced no-load voltage

Possibility to change the polarity - can also be used when welding with gasless filler wire.

Digital display screens allow for accurate parameter monitoring.

Wire feed mechanism with two drive rollers.



Technical specifications


Wire roll 200mm to 5kg

Power supply 1f 230V +-10%

Welding current for MIG welding 50-200A

Welding current for electrode welding 10-160 A

Welding current for TIG welding 10-200 A

Max current consumption 37A

Required mains load protection 25 A C-type

Load capacity 30%- 200 A MIG and 60%- 160 A MMA

Arc voltage for MIG welding 12,3- 26 V

Wire feed speed 2- 12,5 m/min

Weldable wires 0,6-1,0 mm

Wire feed mechanism with two drive wheels

Power factor 0,76

Efficiency 85%

Protection class IP21S

Insulation class H

Dimensions 470x190x300 mm

Weight 9 kg



Included

Ground terminal with 3m cable

Welding torch Spartus Easy 150 3m

Gas hose with clamps

Drive rollers for 0,8-1,0 mm wire.

Electrode holder with 3m cable.