Does not leave an oily residue.
1. Clean the weld with a wire brush, then clean the surface with cleaning aerosol UTI000556. Spray the cleaner on the weld, wait approx. 30 seconds and wipe the surface dry with a cloth or paper towel.
2. Spray red penetrant UTI000553 on the surface. Wait 3-5 minutes. If the temperature is lower than 12 degrees, the time must be longer, if higher than 45 degrees, then shorter. Clean the surface with a penetrant cloth or paper cloth, the cloth may be slightly damp
3. Surface spraying of (white) UTI000555 was revealed. It is recommended to spray 2-3 thin layers, the surface must remain slightly moist. If too thick a layer is applied, the penetrant can cover the developer and the cracks will not be visible. You have to wait up to 5 minutes. The red lines are the reading
Welding cleaning spray 400ml
€9.40
Description
Welding cleaning spray 400ml
Does not leave an oily residue.
Manual:
1. Welding cleaning
The weld must be cleaned with a wire brush, then clean the surface with cleaning spray UTI000556. Spray the cleaner on the weld, wait about 30 seconds and wipe the surface dry with a cloth or paper.
2. Use of penetrants
Spray the red penetrant on the surface of UTI000553. Wait 3-5 minutes. If the temperature is lower than 12 degrees, the waiting time must be longer, if the temperature is higher than 45 degrees, the waiting time must be shorter. Clean the surface of the penetrant with a cloth or paper, the cloth may be slightly moistened.
3. Use of the revealer
Spray the white developer onto the surface of UTI000555. It is recommended to spray 2-3 thin layers, the surface must remain slightly moist. If too thick a layer is applied, the penetrant can cover the developer and the cracks will not be visible. Wait up to 5 minutes. Red lines indicate leaks or cracks.
